Aisin Tf-80 / AM6 Oil Change Questions (Mini-Guide Page 4)

[GiveMeABreak]

Depending on your vehicle's Euro Standard You'll need either:

JWS 3309 for Euro 4 Vehicles
JWS 3324 (Type AM6-2 / AM6-2 / AT6/ AT6-3) - equivalent to AW1 for Euro 5 or Euro 6 Vehicles.

[Harcix]

Yes, that i already do know, its a 2012 508 163hp. Its the JWS 3324 i need. Just wanted to check, if you have any opinions on that particular oil

https://www.mannol.de/create-pdf/270/en

[GiveMeABreak]

We only recommend the official oil, but as long as it meets the specific requirements for the gearbox and Euro standards you should be ok.

[Mostafa Mahmoud]

Hi,I want to know the gearbox type installed in my car
and the oil specs as well. my VIN is VF3**************[VIN obfuscated, can be read by forum staff]
i need a way to help me to know if a certain oil is suitable for my gearbox or not from its specs or datasheet.
thank you

[Mostafa Mahmoud]

Hi
is it ok to use this oil "ATF WS Lifetime" specs are shown in the images
my vin code is VF3**************[VIN obfuscated, can be read by forum staff]

[shelleyamy]

Hello
Can you confirm the oil i should use for VIN VF3**************[VIN obfuscated, can be read by forum staff]
Thanks
Mike

[GiveMeABreak]

MIke, you have a Euro 5 vehicle, so this requires JWS 3324 Gearbox Oil. Don't forget to reset the oil counter with a diagnostic tool and you will need 2-3 changes to get to as near a complete change as you can.

[GiveMeABreak]

Hi
is it ok to use this oil "ATF WS Lifetime" specs are shown in the images
my vin code is VF3**************[VIN obfuscated, can be read by forum staff]

I've only just seen this post, a bit late for a reply but the same for you JWS 3324 Oil for this gearbox.

[mbprado]

Hey!

I was reading the whole topic, and the information here is very clear, however, the vendors they don't help and their specifications are really confusing.
At my car (VF7**************[VIN obfuscated, can be read by forum staff]) transmission oil plug is written AW1, i understood as per Marc's posts that I shouldn't use in any circumstance JWS 3309 spec. What if the oil spec says: AISIN WARNER AW-1 and ATF 3309, like FEBI BILSTEIN 101161 ?

Tks!

[tenxob]

Hi All
Just to update some info.
Just changed EAT6 oil on 208 1.2L THP Allure ( 67 ) and some new info below.
All plugs now have O rings and no flat washers - Level/Drain/Fill
Amount that came out of min was 2.5L - so I put in 3 and when level checking 0.5L came back out.
Car was level and at correct temp etc.
Sorry no pics!
Mike

[Gmsbh]

Hello, I would like some help from everyone to change the oil in my DS5, my VIN code is VF7**************[VIN obfuscated, can be read by forum staff], what would be the correct oil for my car? I'm confused.

[IgorI]

Hello everyone! I have a Citroen C5, 2012, 2.2 liter engine, station wagon, diesel, VIN code VF7**************[VIN obfuscated, can be read by forum staff]. I want to change the oil in the automatic transmission. And the question is - can I use Toyota AT Fluid WS for oil change?

[GiveMeABreak]

You require JWS 3324 oil, or equivalent to this.

[IgorI]

The official Citroen dealer in my city said that Citroen uses special transmission oil for the automatic transmission, its cost is 210 euros for 4 liters. It seemed too expensive to me. A regular Asin transmission.

[GiveMeABreak]

The oils are different, often based on Euro standard of the vehicle (Euro 4 or 5/6) and gearbox (remember there were multiple versions of the AM6 gearbox fitted over the years). You have a Euro 5 vehicle.

The dealer is correct and you did ask - but can't help if you don't like the answer. Yes the oil is expensive, but look for JWS 3324 or equivalent.