P2463 P246C

Unread post by **GORAX** » 12 Nov 2024, 11:21

Now the Light is on. What can i check?

Unread post by **GORAX** » 14 Nov 2024, 21:30

Today I did a regeneration. Was done with Diagbox. Unfortunately, success anyway. In the end Diagbox said exhaust heat not reached. There was a brief burst of blue smoke for a few minutes that smelled like it had been burnt. is this particle filter completely defective?

Unread post by **GORAX** » 16 Nov 2024, 10:58

So DPF is completely clean. But after installation diagbox brings again error exhaust heat not reached. Where do I have to look further?

Unread post by **GORAX** » 19 Nov 2024, 11:21

could it be that the regeneration is not started because adblue and nox are deactivated?

I still have to get the adblue tank, but I can install the NOX sensor now so that it can regenerate again.

Unread post by **GORAX** » 30 Nov 2024, 08:03

Adblue and nox are activated. Works Fine. But Regeneration doesnt still work. Exhaust does not get warmer than 350 degrees. where do I have to look further?

Unread post by **GORAX** » 04 Dec 2024, 09:48

Same issue is Continue. Adblue and nox is active...

Unread post by **GORAX** » 07 Dec 2024, 22:04

I ordered a new dpf/cat system yesterday. will replace everything.

Unread post by **GORAX** » 15 Dec 2024, 19:49

DPF/KAT is changed. All Good now.

Unread post by **Paul-R** » 15 Dec 2024, 19:55

Good to hear. How much did it cost you?

Unread post by **GORAX** » 23 Dec 2024, 08:57

I have buy one for 580 Euro. Cost for change was 100 Euro.

French Car Forum

P2463 P246C

Re: P2463 P246C

Re: P2463 P246C

Re: P2463 P246C

Re: P2463 P246C

Re: P2463 P246C

Re: P2463 P246C

Re: P2463 P246C

Re: P2463 P246C

Re: P2463 P246C

Re: P2463 P246C