Diagbox error 202

[mikekat]

Dear all,
Please help me out. I have diagbox 9.x installed and have a online PSA token.
But my SMEG+ is locked as hell. When i try to automatic code, it does work properly, but when i want to manual telecode; to activate the rear camera, he gives a 202 error.
First i got the question about SERMI code, after asking at the peugeot service they give it to me. Then, while trying manual telecode this error came on.
What could be the issue? I use a good clone adapter.

[GiveMeABreak]

You must use the official version of Diagbox from the Servicebox website where you bought your token. I believe this error comes up with unofficial versions of the software.

[mikekat]

I got the newest and original version from PSA today from them. (version DiagBox_setup_V09.163_POI.exe)
And bought a SRI code from pin-online.net, because the SMEG asked for it.. It goes further but it did not complete the manual telecode because he shown that error. Now i lose my first code. Hope you can help me further.

Edit.
Well, after deinstall that version and install 09.143 it could telecode manual again. So this is fixed.

[Huskyxantia]

Maybe hardware . More than software. Anything that runs on whingdows at some point can play up.