Is it advisable to put some sealer between the cam-housing and cam-cover gasket, perhaps Fel-pro Blue, Wellseal or similar?
Have just removed the rear cam-cover on my TU5JP4 engine as suspect slight oil leak from that gasket. Rubber seems a bit hard but maybe they are like that from new, nothing to compare it against.
Cam-cover gasket sealant?
Moderator: RichardW
-
Huskyxantia
- Donor 2023
- Posts: 2057
- Joined: 30 Jul 2018, 22:11
- x 429
Re: Cam-cover gasket sealant?
Id think it would be ok, ive used the stuff on many over the years , i used to let it semi harden then pop it back on and bolt it up , job done.
Husky. 
-
ozvtr
- Posts: 417
- Joined: 13 Oct 2020, 01:11
- x 125
Re: Cam-cover gasket sealant?
I wouldn't 'add' sealant, the gaskets are good enough. The TU5 cam housing to cover surfaces are flat and will form a satisfactory seal. Adding sealant doesn't make it seal any better or longer.
I would only add sealant where the gasket needs to conform to a sharp 'V' edge or there are 2 castings mating on the gasket surface. There are none of them in the cam cover area.
I would only add sealant where the gasket needs to conform to a sharp 'V' edge or there are 2 castings mating on the gasket surface. There are none of them in the cam cover area.